CTDO2 Calibration Toolbox

Derrick Snowden

Carlos Fonseca

2004-09-25

Revision History
Revision 1.02004-09-25Revised by: dps
first official release

This document describes a Matlab© toolbox which allows CTDO2 data collected with a Sea-Bird© sensor suite to be calibrated against independent analyses of seawater samples.


Table of Contents
Introduction
Obtaining and Installing the CTDCAL Toolbox
Preparing to Calibrate a New Cruise
Calibrating the Pressure Sensor
Calibrating the Temperature Sensors
Calibrating the Conductivity Sensors
Troubleshooting
A. Sea-Bird© Proprietary file formats
Index

Introduction

Provide a good overview and anything else you may think is needed in this area. Looking at other HOWTOs may assist in providing ideas.

Credits / Contributors

Most of the software described in this document was written by Carlos Fonseca. Derrick Snowden has contributed to the software development to a lesser extent. Scientific input to the software development was given by Molly Baringer, Libby Johns, Bill Johns and Bob Molinari. Many of the ideas and algorithms are taken from other packages in use by PMEL. In particular, Greg Johnson and Kristy McTaggert were the primary authors.

Feedback

Feedback is most certainly welcome for this document and for the software it describes. Send your additions, comments and criticisms to the following email address : , or .